Basic Operation Procedure (Pu Operation); Operating At The Set Frequency (Example: Operating At 30 Hz) - Mitsubishi Electric FR-F820-00077 Instruction Manual

Basic operation
4.5

Basic operation procedure (PU operation)

NOTE Where is the frequency command source?
● The frequency set in the frequency setting mode of the operation panel
=> Refer to section 4.5.1 (page 4-13).
● The setting dial used as the potentiometer => Refer to section 4.5.2 (page 4-15).
● The ON/OFF switches connected to terminals => Refer to section 4.5.3 (page 4-16).
● Voltage input signals => Refer to section 4.5.4 (page 4-18).
● Current input signals => Refer to section 4.5.5 (page 4-20).
4.5.1

Operating at the set frequency (example: operating at 30 Hz)

NOTE Use the operation panel (FR-DU08) to give a start command and a frequency command.
FR-F800
Operation panel
(FR-DU08)
Basic operation procedure (PU operation)
Fig. 4-4:
PU operation mode
I002443E
4 - 13