Ethernet communication (FR-F800-E)
Programming example for setting the operation mode
The following explains a program to write various data to the inverter.
The following program changes the operation mode of the station 1 inverter to network operation.
● Operation mode write code: HFB (hexadecimal)
● Network operation set data: H0000 (hexadecimal) (Refer to page 5-622.)
● The reply code at the time of instruction code execution is set to D2. (Refer to page 5-621.)
Programming example 2
5 - 628
Check the data link status of the station 1.
Write the operation mode write code (HFB)
to RWw2 and the set data (H0000) to RWw3.
Turn ON the instruction code execution request
Read the reply code (RWr2) to D2 when the
instruction code execution completion (RX0F) turns
Turn OFF the instruction code execution request