Entering Ip Parameters Via Cli - Hirschmann RS20 User Manual

Entering the IP Parameters
2.2 Entering IP parameters via
CLI
If you do not configure the system via BOOTP/DHCP, DHCP Option 82, the
HiDiscovery protocol or the ACA auto configuration adapter, then you per-
form the configuration via the V.24 interface using the CLI.
Entering IP addresses
Connect the PC with terminal
program started to the RJ11 socket
Command Line Interface
starts after key press
Log in and change to the
Privileged EXEC Mode
Switch off DHCP,
enter and save IP parameters
End of entering IP addresses
Figure 9: Flow chart for entering IP addresses
If there is no terminal or PC with terminal emulation available in the vicinity of
the installation location, you can enter the IP parameters at your own work-
station prior to the ultimate installation.
32

2.2 Entering IP parameters via CLI

Basic Configuration L2P
Release 4.2 07/08