Entering Ip Parameters Via Cli - Hirschmann RS20 User Manual

Entering the IP Parameters
2.2 Entering IP parameters via
CLI
If you do not configure the system via BOOTP/DHCP, DHCP Option 82, the
HiDiscovery protocol or the AutoConfiguration Adapter ACA, then you
perform the configuration via the V.24 interface using the CLI.
Entering IP addresses
Connect the PC with terminal
program started to the RJ11 socket
Command Line Interface
starts after key press
Log in and change to the
Privileged EXEC Mode
Enter and save IP parameters
End of entering IP addresses
Figure 8: Flow chart for entering IP addresses
32

2.2 Entering IP parameters via CLI

UM BasicConfig L2E
Release 8.0 05/2013