Mode-Based Command Line Interface - Hirschmann PowerMICE Reference Manual

3.0 Mode-based Command Line Interface

The Command Line Interface (CLI) groups all the commands in appropriate modes according to the
nature of the commands. A sample of the CLI command modes is described below. Each of the
command modes supports specific switch software commands. The name „switch" in the following
table is standing in for the name of the device.
Table 6. CLI Command Modes captures the command modes, the prompts visible in that mode and the
exit method from that mode.
Table 6. CLI Command Modes
Command
User EXEC
Mode
Privileged EXEC
Mode
VLAN Mode
Global Config
Mode
Interface Config
Mode
Line Config
Mode
Mode-based Command Line Interface
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
Access Method
Mode
This is the first
level of access.
Perform basic
tasks and list sys-
tem information.
From the User
EXEC mode,
enter the
command.
From the Privi-
leged EXEC
mode, enter the
vlan database
command.
From the Privi-
leged EXEC
mode, enter the
configure
command.
From the Global
Config mode,
enter the
<slot/port>
face
command.
From the Global
Config mode,
enter the
lineconfig
command.
Switch>
Switch#
enable
Switch (Vlan)#
Switch (Config)#
Switch (Interface <unit/slot/port>)#
inter-
Switch (line)#
Prompt
Exit or Access
Previous Mode
Enter Logout
command
To exit to the User
EXEC mode,
enter or
exit
press .
Ctrl-Z
To exit to the Priv-
ileged EXEC
mode, enter the
command,
exit
or press
Ctrl-Z
to switch to the
User EXEC mode.
To exit to the Priv-
ileged EXEC
mode, enter the
command,
exit
or press
Ctrl-Z
to switch to the
User EXEC mode.
To exit to the Glo-
bal Config mode,
enter the
exit
command. To
return to the User
EXEC mode,
enter .
Ctrl-Z
To exit to the Glo-
bal Config mode,
enter the
exit
command. To
return to the User
EXEC mode,
enter .
Ctrl-Z
12