Info-Center Synchronous - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

console: Outputs logs to the console.
logbuffer: Outputs logs to the log buffer.
logfile: Outputs logs to a log file.
loghost: Outputs logs to the log host.
monitor: Outputs logs to the monitor terminal.
deny: Disables log output.
level severity: Specifies a severity level in the range of 0 to 7. See
this keyword, you can specify the lowest severity level of the logs allowed/denied to be output.
Usage guidelines
This command sets an output rule for a specified module or all modules. For example, you can output IP
log information with a severity of at least warning to the log host, and output IP log information with a
severity of at least informational to the log buffer.
If you do not set an output rule for a module, the module uses the default output rule or the output rule set
by using the default keyword.
If you use the command multiple times, only the most recent output rule takes effect for the specified
module.
After you set an output rule for a module, you must use the module-name argument to modify or remove
the rule. A new output rule configured by using the default keyword does not take effect on the module.
Examples
# Output only VLAN module's information with a severity level of at least emergency to the console.
<Sysname> system-view
[Sysname] info-center source default console deny
[Sysname] info-center source vlan console level emergency
# Based on the previous configuration, disable output of VLAN module's information to the console so no
system information is output to the console.
<Sysname> system-view
[Sysname] undo info-center source vlan console

info-center synchronous

Use info-center synchronous to enable synchronous information output.
Use undo info-center synchronous to disable synchronous information output.
Syntax
info-center synchronous
undo info-center synchronous
Default
Synchronous information output is disabled.
Views
System view
Table 44
228
for more information. With