HP FlexFabric 12500 Series Network Management And Monitoring Command Reference page 253

interval interval: Specifies the interval to sample the monitored traffic statistic for a comparison. The value
range is 1 to 4294967295 seconds. The default is 300 seconds.
Table 51 Monitored objects
Monitored traffic statistic
input-drops
input-errors
output-drops
output-errors
rcv-bps
rcv-broadcasts
rcv-pps
tx-bps
tx-pps
Table 52 Comparison operators
Comparison operator
eq
ge
gt
le
lt
ne
Usage guidelines
Use interface event monitor policies to monitor traffic statistics on an interface.
EAA uses the following process to monitor a traffic statistic for an interface event:
1. Compares the traffic statistic sample with the start threshold at sampling intervals by using the start
operator until the comparison result meets the condition.
2. Executes the policy.
3. Compares the traffic statistic sample with the restart threshold at sampling intervals by using the
restart operator until the comparison result meets the condition.
4. Executes the policy again.
This process cycles for the monitor policy to be executed and re-executed.
You can configure only one event for one monitor policy. If the monitor policy already contains an event,
the new event replaces the old event.
Examples
# Configure a CLI-defined policy to monitor incoming error packet statistic on GigabitEthernet 3/0/1
every 60 seconds. Enable the system to execute the policy when the traffic statistic is greater than the start
Description
Number of discarded incoming packets.
Number of incoming error packets.
Number of discarded outgoing packets.
Number of outgoing error packets.
Receive rate, in bps.
Number of incoming broadcasts.
Receive rate, in packets per second.
Transmit rate, in bps.
Transmit rate, in packets per second.
Description
Equal to.
Greater than or equal to.
Greater than.
Less than or equal to.
Less than.
Not equal to.
245