Download  Print this page

HP FlexFabric 12500 Series Network Management And Monitoring Command Reference: Tracert

Routing.
Hide thumbs

Advertisement

Field
round-trip min/avg/max/ std-dev
=4.000/25.000/62.000/20.000
ms

tracert

Use tracert to trace the path the packets traverse from source to destination.
Syntax
tracert [ -a source-ip | -f first-ttl | -m max-ttl | -p port | -q packet-number | -t tos | -vpn-instance
vpn-instance-name | -w timeout ] * host
Views
Any view
Predefined user roles
network-admin
mdc-admin
Parameters
-a source-ip: Specifies an IP address of the device as the source IP address of probe packets. If this option
is not specified, the source IP address of probe packets is the primary IP address of the outbound
interface.
-f first-ttl: Specifies the TTL of the first packet sent to the destination. The value range is 1 to 255, and the
default is 1. It must be no greater than the value of the max-ttl argument.
-m max-ttl: Specifies the maximum number of hops allowed for a probe packet. The value range is 1 to
255, and the default is 30. It must be no smaller than the value of the first-ttl argument.
-p port: Specifies an invalid UDP port of the destination. The value range is 1 to 65535, and the default
is 33434.
-q packet-number: Specifies the number of probe packets to send per hop. The value range is 1 to 65535,
and the default is 3.
-t tos: Specifies the ToS value in a tracert packet. The value range is 0 to 255, and the default is 0.
-vpn-instance vpn-instance-name: Specifies the MPLS L3VPN instance to which the destination belongs,
where the vpn-instance-name argument is a case-sensitive string of 1 to 31 characters. If the destination
is on the public network, do not specify this option.
-w timeout: Specifies the timeout time in milliseconds of the reply packet for a probe packet. The value
range is 1 to 65535, and the default is 5000.
host: Specifies the IP address or host name of the destination. The host name is a case-insensitive string
of 1 to 253 characters. It can contain letters, digits, and special characters such as hyphen (-), underscore
(_), and dot (.).
Usage guidelines
After identifying network failure with the ping command, use the tracert command to locate failed nodes.
The output of the tracert command includes IP addresses of all the Layer 3 devices that the packets
traverse from source to destination. Asterisks (* * *) are displayed if the device cannot reply with an
Description
Minimum/average/maximum/standard deviation response time, in
milliseconds.
8

Advertisement

   Also See for HP FlexFabric 12500 Series

   Related Manuals for HP FlexFabric 12500 Series

This manual also for:

Flexfabric 12500e series

Comments to this Manuals

Symbols: 0
Latest comments: