ICMP error message (this can be because the destination is unreachable or sending ICMP
timeout/destination unreachable packets is disabled).
To abort the tracert operation during the execution of the command, press Ctrl+C.
# Display the path that the packets traverse from source to destination (220.127.116.11).
<Sysname> tracert 18.104.22.168
traceroute to 22.214.171.124(126.96.36.199), 30 hops at most, 40 bytes each packet, press CTRL_C to
188.8.131.52 (184.108.40.206) 673 ms 425 ms 30 ms
220.127.116.11 (18.104.22.168) 580 ms 470 ms 80 ms
# Trace the path to destination (192.168.0.46) over an MPLS network.
<Sysname> tracert 192.168.0.46
traceroute to 192.168.0.46(192.168.0.46), 30 hops at most, 40 bytes each packet, press
CTRL_C to break
MPLS Label=100048 Exp=0 TTL=1 S=1
MPLS Label=100016 Exp=0 TTL=1 S=1
Table 3 Command output
traceroute to 22.214.171.124(126.96.36.199)
hops at most
bytes each packet
press CTRL_C to break
1 188.8.131.52 (184.108.40.206) 673 ms
425 ms 30 ms
MPLS Label=100048 Exp=0
Display the route that the IP packets traverse from the current device to the
device whose IP address is 220.127.116.11.
Maximum number of hops of the probe packets, which can be set by the -m
Number of bytes of a probe packet.
During the execution of the command, press Ctrl+C to abort the tracert
Probe result of the probe packets whose TTL is 1, including the domain name
(or IP address, if the domain name is not configured) of the first hop, and the
round-trip time of the three probe packets.
The number of packets that can be sent in each probe can be set through the
ICMP timeout packets on an MPLS network, carrying MPLS label information:
Label—Label value that is used to identify a forwarding equivalence class
Exp—Reserved, usually used for class of service (CoS).
S—MPLS supports multiple levels of labels. Value 1 indicates that the label
is at the bottom of the label stack, and value 0 indicates that the label is in
another label stack.