Mirroring-Group Mirroring-Vlan - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

Parameters
group-id: Specifies the number of a mirroring group, in the range of 1 to 64. The mirroring group
specified by the group-id argument must already exist.
interface-list: Source port list, containing one or more ports, in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] }&<1-8>. The interface-type
interface-number argument specifies an interface by its type and number. &<1-8> indicates that you can
specify up to eight interface-type interface-number [ to interface-type interface-number ] parameters.
When you use to to specify an interface range, the start and end interfaces must be of the same type on
the same card, and the end interface number must be equal to or greater than the start port number.
both: Mirrors both received and sent packets on the specified ports.
inbound: Mirrors only received packets on the specified ports.
outbound: Mirrors only sent packets on the specified ports.
Usage guidelines
You can configure source ports only for local mirroring groups or remote source groups but not for remote
destination groups.
Do not assign source ports to source VLANs or remote probe VLANs.
Typically, a port belongs to only one mirroring group.
Do not configure flow sampling on a source port from which the outbound packets are mirrored.
Examples
# Create local mirroring group 1, configure GigabitEthernet 3/0/1 as a source port of the mirroring
group, and configure the mirroring group to monitor the bidirectional traffic of the port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 mirroring-port GigabitEthernet 3/0/1 both
# Create remote source group 2, configure GigabitEthernet 3/0/2 as a source port of the mirroring
group, and configure the mirroring group to monitor the bidirectional traffic of the port.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] mirroring-group 2 mirroring-port GigabitEthernet 3/0/2 both
Related commands
mirroring-group

mirroring-group mirroring-vlan

Use mirroring-group mirroring-vlan to configure source VLANs for a mirroring group.
Use undo mirroring-group mirroring-vlan to remove the specified source VLANs from a mirroring group.
Syntax
mirroring-group group-id mirroring-vlan vlan-list { both | inbound | outbound }
undo mirroring-group group-id mirroring-vlan vlan-list
Default
No source VLAN is configured for a mirroring group.
185