[Sysname-rtm-test] action 3 reboot
# (In IRF mode.) Configure an action for the CLI-defined policy test to reboot IRF member device 1.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 reboot chassis 1
action switchover
Use action switchover to add an active/standby switchover action to a monitor policy.
Use undo action to remove an action.
Syntax
action number switchover
undo action number
Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
mdc-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
Usage guidelines
This command is supported only on the default MDC.
In standalone mode, this command reboots the device if the device has only one MPU.
In IRF mode, this command reboots the device if the device forms a single-chassis IRF fabric and has only
one MPU.
You can configure a series of actions to be executed in response to the event specified in a monitor policy.
EAA executes the actions in ascending order of action IDs. You must make sure the execution order is
correct when you add actions to a policy.
Examples
# Configure an action for the CLI-defined policy test to perform an active/standby switchover.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 switchover
action syslog
Use action syslog to add a Syslog action to a monitor policy.
Use undo action to remove an action.
238