Enable Snmp Trap Updown - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

Routing
Hide thumbs Also See for FlexFabric 12500 Series:
Table of Contents

Advertisement

Field
UserStatus
ACL
Related commands
snmp-agent usm-user v3

enable snmp trap updown

Use enable snmp trap updown to enable link state notifications on an interface.
Use undo enable snmp trap updown to disable link state notifications on an interface.
Syntax
enable snmp trap updown
undo enable snmp trap updown
Default
Link state notifications are enabled.
Views
Interface view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Usage guidelines
For an interface to generate linkUp/linkDown notifications when its state changes, you must also enable
the linkUp/linkDown notification function globally using the snmp-agent trap enable standard
[ linkdown | linkup ] * command.
Examples
# Enable port GigabitEthernet 3/0/1 to send linkUp/linkDown SNMP traps to 10.1.1.1 in the community
public.
<Sysname> system-view
Description
SNMP user status:
active—The SNMP user is effective.
notInService—The SNMP user is correctly configured but not activated.
notReady—The SNMP user configuration is incomplete.
other—Any other status.
SNMP users are active upon their creation at the CLI. To temporarily disable an
SNMP user without deleting it, you can perform an SNMP set operation to change
its status.
Number of the ACL that controls the access of the SNMP user (the NMS) to the
device.
To access the device, the IP address of the NMS must be permitted in the ACL.
This field appears only when an SNMPv3 user is associated with an ACL rule.
130

Advertisement

Table of Contents
loading

This manual is also suitable for:

Flexfabric 12500e series

Table of Contents