Source Ipv6 - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

Predefined user roles
network-admin
mdc-admin
Parameters
ip-address: Specifies the source IP address of the operation.
Usage guidelines
If you configure both the source interface command and the source ip command for an ICMP echo
operation, the most recent configuration takes effect.
The specified source IP address must be the IP address of a local interface. The local interface must be up.
Otherwise, no probe packets can be sent out.
For an NQA template, if the source and destination addresses have different IP versions, the source
address does not take effect.
Examples
# Configure the source IP address for ICMP echo requests as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1
# In ICMP template view, configure the source IP address for ICMP echo requests as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa template icmp icmptplt
[Sysname-nqatplt-icmp-icmptplt] source ip 10.1.1.1
Related commands
source interface

source ipv6

Use source ipv6 to configure the source IPv6 address for probe packets.
Use undo source ipv6 to remove the configured source IPv6 address. The IPv6 address of the interface
that sends a probe packet serves as the source IPv6 address of the probe packet.
Syntax
source ipv6 ipv6-address
undo source ipv6
Default
No source IPv6 address is configured for probe packets.
Views
Any NQA template view
Predefined user roles
network-admin
mdc-admin
70