mirroring-group group-id reflector-port interface-type interface-number
undo mirroring-group group-id reflector-port interface-type interface-number
In interface view:
mirroring-group group-id reflector-port
undo mirroring-group group-id reflector-port
No reflector port is configured for a mirroring group. A port does not serve as the reflector port for a
System view, interface view
Predefined user roles
group-id: Specifies the number of a mirroring group, in the range of 1 to 64. The mirroring group
specified by group-id must already exist.
interface-type interface-number: Specifies a port to be configured as the reflector port by its type and
You can configure reflector ports only for remote source groups but not for local mirroring groups or
remote destination groups.
Do not assign the reflector port to a source VLAN.
Select a port not in use on the device to be configured as the reflector port. Do not connect a network
cable to the reflector port.
When a port is configured as a reflector port, all existing configuration of the port is cleared. You cannot
configure other features on the reflector port.
You can configure a port as a reflector port only when the port is operating with the default duplex mode,
port rate, and MDI setting. In addition, you cannot change these settings after the port is configured as
a reflector port.
# Create remote source group 1 and configure port GigabitEthernet 3/0/1 as its reflector port in system
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port GigabitEthernet 3/0/1
This operation may delete all settings made on the interface. Continue? [Y/N]: y
# Create remote source group 2 and configure port GigabitEthernet 3/0/2 as its reflector port in
[Sysname] mirroring-group 2 remote-source
[Sysname] interface GigabitEthernet 3/0/2