Configuring Cpe Attributes; Configuring Acs Authentication Parameters; Configuring The Provision Code - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
5. (Optional.)
password for authentication
to the default ACS URL.

Configuring CPE attributes

You can assign CPE attribute values to the CPE from the CPE's CLI or the ACS. The CLI- and
ACS-assigned values overwrite each other, whichever is assigned later.
For more information about the configuration methods supported for each CPE attribute, see
"Configuration task

Configuring ACS authentication parameters

To protect the CPE against unauthorized access, configure a CPE username and password for ACS
authentication. When an ACS initiates a connection to the CPE, the ACS must provide the correct
username and password.
NOTE:
The password setting is optional. You may choose to use only a username for authentication.
To configure ACS authentication parameters:
Step
1. Enter system view.
2. Enter CWMP view.
3. Configure the username for
authentication to the CPE.
4. (Optional.)
password for authentication
to the CPE.

Configuring the provision code

The ACS uses the provision code to identify services assigned to each CPE. For correct
configuration deployment, make sure the same provision code is configured on the CPE and the
ACS.
To configure the provision code:
Step
1. Enter system view.
2. Enter CWMP view.
3. Configure
code.
Command
Configure the
cwmp acs default password
{ cipher | simple } password
list."
Command
system-view
cwmp
cwmp cpe username username
Configure the
cwmp cpe password { cipher |
simple } password
Command
system-view
cwmp
the provision
cwmp
provision-code
cpe provision-code
210
Remarks
By default, no password has been
configured for authentication to
the default ACS URL.
Remarks
N/A
N/A
By default, no username has been
configured for authentication to
the CPE.
By default, no password has been
configured for authentication to
the CPE.
Remarks
N/A
N/A
The default provision code is
PROVISIONINGCODE.