Port Isolation Commands; Display Port-Isolate Group - HPE FlexNetwork 5130 EI Series Command Reference Manual

Port isolation commands

display port-isolate group

Use display port-isolate group to display port isolation group information.
Syntax
display port-isolate group [ group-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group-id : Specifies an isolation group by its ID. The value range is 1 to 8.
Examples
# Display all isolation groups.
<Sysname> display port-isolate group
Port isolation group information:
Group ID: 1
Group members:
GigabitEthernet1/0/1
Group ID: 5
Group members:
GigabitEthernet1/0/2
# Display information about isolation group 1.
<Sysname> display port-isolate group 1
Port isolation group information:
Group ID: 1
Group members:
GigabitEthernet1/0/1
Table 23 Command output
Field
Group ID
Group members
Related commands
port-isolate enable
GigabitEthernet1/0/4
Description
ID of the isolation group.
Isolated ports in the isolation group. No ports indicates
that the isolation group contains no isolated ports.
105