Configuring A Remote Source Group On The Source Device - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
2. Enter the interface view of
the monitor port.
3. Assign the port to the
remote probe VLAN.

Configuring a remote source group on the source device

Creating a remote source group
Step
1. Enter system view.
2. Create a remote source
group.
Configuring source ports for a remote source group
To configure source ports for a mirroring group, use one of the following methods:
•
Assign a list of source ports to the mirroring group in system view.
•
Assign a port to the mirroring group as a source port in interface view.
To assign multiple ports to the remote source group as source ports in interface view, repeat the
operation.
When you configure source ports for a remote source group, follow these restrictions and guidelines:
•
Do not assign a source port of a remote source group to the remote probe VLAN of the remote
source group.
•
A mirroring group can contain multiple source ports.
•
A source port cannot be used as a reflector port, monitor port, or egress port.
•
A port can be assigned to different mirroring groups as follows:
When acting as a source port for unidirectional mirroring, the port can be assigned to up to

four mirroring groups.
When acting as a source port for bidirectional mirroring, the port can be assigned to up to

two mirroring groups.
When acting as a source port for unidirectional and bidirectional mirroring, the port can be

assigned to up to three mirroring groups. One mirroring group is used for bidirectional
mirroring and the other two for unidirectional mirroring.
Configuring source ports for a remote source group in system view
Step
1. Enter system view.
Command
interface
interface-number
•
For an access
port access vlan vlan-id
•
For a trunk
port trunk permit vlan vlan-id
•
For a hybrid
port hybrid vlan vlan-id { tagged |
untagged }
Command
system-view
mirroring-group
remote-source
Command
system-view
165
Remarks
interface-type
N/A
port:
For more information about the
port access vlan, port trunk
port:
permit vlan, and port hybrid
vlan commands, see Layer
port:
2—LAN Switching Command
Reference.
Remarks
N/A
group-id By default, no remote source
group exists on a device.
Remarks
N/A