Info-Center Loghost Source; Info-Center Security-Logfile Alarm-Threshold - HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference

info-center loghost source

Use info-center loghost source to specify a source IP address for logs sent to log hosts.
Use undo info-center loghost source to restore the default.
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
Default
The source IP address of logs sent to log hosts is the primary IP address of the outgoing interface.
Views
System view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
The system uses the primary IP address of the specified interface as the source IP address of the
logs sent to log hosts.
The info-center loghost source command takes effect only after the information center is enabled
by using info-center enable command.
Examples
# Use the IP address of interface Loopback 0 as the source IP address of the logs sent to log hosts.
<Sysname> system-view
[Sysname] interface loopback 0
[Sysname-LoopBack0] ip address 2.2.2.2 32
[Sysname-LoopBack0] quit
[Sysname] info-center loghost source loopback 0

info-center security-logfile alarm-threshold

Use info-center security-logfile alarm-threshold to set the alarm threshold for security log file
usage.
Use undo info-center security-logfile alarm-threshold to restore the default.
Syntax
info-center security-logfile alarm-threshold usage
undo info-center security-logfile alarm-threshold
Default
The alarm threshold for security log file usage is 80. When the usage of the security log file reaches
80%, the system outputs a message to inform the administrator.
Views
System view
342