Front Paper Guide Assy/Apg Sensor Assy - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390

4.5.14 Front Paper Guide Assy/APG Sensor Assy

Do not touch the surface of the rubber roller of the EJ Roller Assy
and the coated part of the PF Roller Assy as it can adversely affect
the print quality.
Parts/Components need to be removed in advance
All exterior parts/components / All control boards / Middle Housing / Printer
Mechanism / CR Scale / APG Unit / Printhead / Ink System / ASF Unit / Upper Paper
Guide / CR Motor / EJ Frame Assy / PF Encoder / PF Scale / CR Unit
Removal procedure
Refer to the Orientation Definition below for the directions
indicated in the following procedures.
"4.1.6 Orientation Definition (p.61)"
•
Removing the Front Paper Guide Assy
1. Remove the screw and remove the Parallelism Bushing L.
Screw : C.B.S. M3x8 (tightening torque: 6-8 kgf.cm)
•
Figure 4-156. Removing the Parallelism Bushing L
Disassembly/Assembly
Parallelism Bushing L
Front Paper Guide Assy
Disassembly of the Printer Mechanism
2. Disconnect the connector of the PE Sensor Cable on the rear side of the
printer.
3. Remove the screw that secures the Front Paper Guide Assy.
• Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
Connector
PE Sensor Cable
Figure 4-157. Removing the PE Sensor Cable
4. Pull out the EJ Ground Spring to the front side.
Front Paper Guide Assy
Figure 4-158. Removing the EJ Ground Spring
Revision B
Front Paper Guide Assy
EJ Ground Spring
109