Yamaha RIVAGE PM10 Operation Manual page 70

Part Names & Functions  Precautions regarding using the NETWORK connector
Precautions regarding using the NETWORK connector
Each component in the RIVAGE PM10 system features a NETWORK connector on the rear panel. Do not connect these connectors to any unsupported devices (such as a computer you might use to update the
firmware or for external control).
Otherwise, unexpected input of communications traffic may jeopardize system operation.
In particular, never connect the NETWORK connectors on multiple components to the same network switch.
These connectors are usually connected to each other via the system network. Therefore, connecting them to the network switch will generate a loop that could prevent normal system communications.
NETWORK connector on each component
RPio622 RPio222
(rear panel)
DSP-R10 (rear panel)
(rear panel)
CS-R10
(rear panel)
Exclusively
used for
firmware
update
Exclusively
used for
firmware
update
Connector for a
computer for
external control
Connector for a
computer for
external control
Do NOT connect multiple components to the network switch
RPio622 RPio222
DSP-R10
These will be connected to
each other internally via the
console network.
CS-R10
70
CONTENTS FUNCTION MAP
Do not connect multiple
components to the
network switch.
(Otherwise, an Ethernet
loop will be generated.)
These will be connected to
each other internally via the
I/O Network.
RIVAGE PM10 Operation Manual