Yamaha RIVAGE PM10 Operation Manual page 168

CH Parameter  GAIN/SILK
% GANG button
This is shown only in the case of stereo. If this is on, the difference in the LR analog gain is
maintained as the value changes.
The same applies to digital gain.
4.
Use the on-screen buttons and screen encoders to make HA settings.
NOTE
• The PAD will be switched on or off internally when the HA gain is adjusted between +11 dB
and +12 dB.
• Keep in mind that noise may be generated when using phantom power if there is a difference
between the Hot and Cold output impedance of an external device connected to the input
jack.
• The ANALOG GAIN knob and +48V button are enabled for the input jacks of an I/O rack and
the OMNI IN jacks of the control surface.
• HA settings can also be made in the SYSTEM CONFIG parameter settings screen
5.
Edit the SILK settings as needed.
NOTE
SILK settings can also be made in the SYSTEM CONFIG parameter settings screen
6.
Perform the same operations for other input channels as desired.
If you are viewing the GAIN/SILK popup window, you can also use the [SEL] keys to switch
the channel for editing.
7.
When you finish making settings, press the X symbol in the upper right of the
window.
■ Controlling via the SELECTED CHANNEL VIEW screen
1.
Press the [VIEW] key to access the SELECTED CHANNEL VIEW screen.
2.
Select the channel that you want to operate.
3.
Press the ANALOG GAIN knob, the SILK [TEXTURE] knob, or the DIGITAL GAIN
knob to open the GAIN/SILK popup window
(page 111).
(page 111).
168
CONTENTS
(page 167).
ANALOG GAIN knob in the
SELECTED CHANNEL VIEW screen
SILK [TEXTURE] knob in the
SELECTED CHANNEL VIEW screen
DIGITAL GAIN knob in the
SELECTED CHANNEL VIEW screen
RIVAGE PM10 Operation Manual
FUNCTION MAP