Yamaha RIVAGE PM10 Operation Manual page 149

Monitor  CUE
SOLO SAFE popup window (INPUT)
1
1 Tabs
You can select desired input channels and/or output channels as the Solo Safe target. When you
switch the INPUT/OUTPUT tabs, the following buttons will appear to enable you to select
channels.
• If you select the INPUT tab:
CH1-CH144 buttons
• If you select the OUTPUT tab:
MIX 1-MIX 72, MATRIX 1-MATRIX 36, ST A L, ST A R, ST B L, and ST B R buttons
SOLO SAFE popup window (OUTPUT)
6.
Select input channels that will be excluded from Solo operations. (You can
specify more than one.)
The channels specified here will not be muted in Solo mode. The Solo Safe function is useful if
you do not want to accidentally mute certain channels during Solo operations, such as the
main Stereo channels, or Mix channels that send out mix signals to an external recorder.
7.
Press the [CUE] key of a desired channel or DCA to turn it on.
Only the corresponding channel or DCA will be output to the buses and output jacks; other
channels and DCAs will be muted. The same signal will also be output from the CUE OUT
jacks and the MONITOR OUT jacks.
NOTE
If you turn on the [CUE] key of an output channel, the signal will be sent only to the
corresponding bus.
8.
To defeat Solo, press the currently-on SOLO ON/OFF button once again.
NOTE
If you select the LAST CUE button to switch from LAST CUE mode to MIX CUE mode (or vice
versa), all previously-enabled Cue (Solo) signals will be defeated.
149
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual