Yamaha RIVAGE PM10 Operation Manual page 109

System Setup  SYSTEM CONFIG
For a DSP engine
1.
Press the SETUP button on the menu bar to access the SETUP screen.
2.
Press the SYSTEM CONFIG button to access the SYSTEM CONFIG popup
window.
3.
Press the DSP button to access the SYSTEM CONFIG [DSP] popup window.
3
1
2
5
7
8
1 DSP popup button
This button represents the DSP engine that is connected to the system. The row at the top of
the button shows the power supply status of POWER A and B (green: power on, red: power
off). The device icon indicates the device status (green: normal; yellow: abnormal, red: critical
error).
2 Optical reception power status display
This section indicates the power status and readings of the optical receiver for communication
on the TWINLANe network.
Green: Normal
Yellow: Low optical reception power
Red "LOW": No reception
It also indicates the type of HY cards (MMF:HY256-TL; SMF:HY256-TL-SMF) and the total
length of the cables.
4
9
) !
6
@
3 Channel assign popup buttons (MIX 1–72)
When you press a button, a TWINLANe CONFIGURATION popup window appears, in
which you can assign the MIX channel to the TWINLANe network
4 Channel assign popup buttons (STEREO/MATRIX/MONITOR/CUE/TB)
When you press a button, an TWINLANe CONFIGURATION popup window appears, in
which you can assign the STEREO channel, MATRIX channel, MONITOR, CUE, or
TALKBACK to the TWINLANe network
5 Channel assign popup buttons (DIRECT OUT 1-72)
6 Channel assign popup buttons (DIRECT OUT 73-144)
When you press a button, an TWINLANe CONFIGURATION popup window appears, in
which you can assign the direct out to the TWINLANe network.
7 Channel insert assignment buttons
These buttons are used to assign channels to the TWINLANe network so that the external
hardware can be inserted to those channels via the connectors on the I/O rack
8 Channel assignment indication
This area shows the number of channels assigned in the TWINLANe CONFIGURATION
popup window.
9
HIGH Fs FORMAT select buttons
When a Mini-YGDAI card is using high sampling (88.2 kHz, 96 kHz), these buttons enable
#
you to select the operating mode as DOUBLE SPEED, DOUBLE CHANNEL, or SINGLE for
IN and OUT respectively.
NOTE
$
This setting will be ignored if you try to specify the operating mode for an MY card that does not
support high sampling.
) MY SLOT (1–2) popup buttons
Press a button to open the MY CARD SELECT window, in which you can select a Mini-
YGDAI card.
! HY SLOT (3–4) popup buttons
Press a button to open the HY CARD SELECT window, in which you can select an HY card.
@ Parameter settings popup buttons
Press a button to access a popup window, in which you can set the parameters of each card.
# REVERT ALL button
When you press this button, all changes in channel assignments that you made up to that point
will be canceled, reverting to the state prior to the changes.
$
APPLY button
When you press this button, the channel assignment number changes you made are applied to
the TWINLANe network.
109
CONTENTS FUNCTION MAP
(page 110).
(page 110).
(page 183).
RIVAGE PM10 Operation Manual