Yamaha RIVAGE PM10 Operation Manual page 195

CH Parameter  SENDS TO/SENDS FROM
1.
Verify that an output port is assigned to the MIX/MATRIX bus to which the
signal is sent, and that the corresponding output port is connected to the
monitor system or an external effect processor.
2.
Use the top panel [SEL] keys to select the channel that will send a signal to the
MIX/MATRIX bus.
3.
Press the MIX/MATRIX SENDS [PRE] key to switch the send point to PRE or
POST.
NOTE
If the send destination is set to FIXED, the MIX/MATRIX SENDS [PRE] key is unavailable.
4.
Press the MIX/MATRIX SENDS [ON] key to turn it on.
5.
Use the MIX/MATRIX SENDS knobs of the Selected Channel section to adjust
the send levels to the MIX/MATRIX buses.
NOTE
• If the send-destination bus is stereo, the left knob adjusts the pan/balance and the right knob
adjusts the send level.
• To monitor the signal that is being sent to a specific MIX/MATRIX bus, recall the
corresponding MIX/MATRIX channel and press the corresponding [CUE] key.
6.
Use the top panel [SEL] keys to switch channels, and adjust the send levels to all
MIX/MATRIX buses in the same way.
Using the faders to adjust the sends (SENDS ON FADER mode)
You can use the top panel faders to adjust the signals that are sent from a specific channel to the
MIX/MATRIX buses.
1.
Verify that an output port is assigned to the MIX/MATRIX bus to which the
signal is sent, and that the corresponding output port is connected to the
monitor system or an external effect.
2.
Press the SENDS ON FADER button on the menu bar or press the top panel
[SENDS ON FADER] key to access the SENDS ON FADER popup window.
The RIVAGE PM10 system switches to SENDS ON FADER mode, and the SENDS ON
FADER popup window appears. The faders in the Channel Strip section move to indicate the
send level of the signals that are routed from each channel to the currently-selected MIX/
MATRIX bus. The [ON] keys also change to the SEND ON status.
2
195
CONTENTS FUNCTION MAP
1 3
4
RIVAGE PM10 Operation Manual