Yamaha RIVAGE PM10 Operation Manual page 191

CH Parameter  SENDS TO/SENDS FROM
■ Controlling the delay via the SELECTED CHANNEL VIEW screen
1.
Press the [VIEW] key to access the SELECTED CHANNEL VIEW screen.
DELAY field
2.
Select the channel that you want to edit.
3.
Use the corresponding screen encoder or the [TOUCH AND TURN] knob to
adjust the delay parameters.
4.
Set the insert point if necessary.
Use the DELAY popup window (page 188) to set the insert point.
NOTE
For information on monitor/cue delay, refer to
SELECTED CHANNEL VIEW screen
page 136.
SENDS TO/SENDS FROM
Using SENDS TO
By using SENDS TO, you can specify the sends to a specific MIX or MATRIX bus for 12 channels at
a time.
1.
Press the [VIEW] key to access the OVERVIEW screen.
2.
Use the MIX/MATRIX SENDS [MIX]/[MATRIX] keys to switch the type of send-
destination bus.
3.
Use the MIX/MATRIX SENDS [1-12]/[13-24]/[25-36]/[37-48]/[49-60]/[61-72]
keys to select a bank of send-destination buses.
4.
Select the SEND knob of the corresponding send-destination MIX/MATRIX bus,
and press it again to access the SENDS TO popup window.
NOTE
When MATRIX channels are selected, pressing the SEND knob again will access the SENDS
FROM popup window (page 193).
191
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual