Yamaha RIVAGE PM10 Operation Manual page 33

Oscillator
SOLO
"Solo" is a function that outputs only the signal of a specific input channel or output channel. Only
the signal of the channel whose [CUE] key is pressed is output, and the other channels are muted.
The signal of a channel whose [CUE] key is pressed can also be monitored from the CUE OUT
jacks, MONITOR OUT jacks, and PHONES jack.
• SOLO SAFE
As necessary, you can select channels that will not be muted when Solo is performed.
Channel Mode/Bay Mode
You can choose one of two modes: "Channel Mode" which lets you specify the CUE A/B destination
of each channel, and "Bay Mode" which lets you specify the cue destination of each control surface
bay being operated. The choice of Channel Mode or Bay Mode is made in the PREFERENCES page.
• Channel Mode
This mode assumes that one operator is using two cue buses separately. Each channel's cue
audio destination (Cue A, B, A+B) can specified individually.
Bay L
Ch1 2 3
CUE A B A CUE
Cue B
(Wedge)
• Bay Mode
This mode assumes two operators will operate the system. You can specify the cue destination
(CUE A and B) for each Bay.
Bay L
Cue=B
Ch1 2 3
CUE B B B CUE
Cue B
(Phones B)
Bay C Bay R
Ch1 2 3 Ch1 2 3
A B A CUE A B A
Cue A
(Phones)
Bay C Bay R
Cue=A Cue=A
Ch1 2 3 Ch1 2 3
A A A CUE A A A
Cue A
(Phones A)
Oscillator
The RIVAGE PM10 features two oscillators that output individual sine waves with different
frequencies to the desired channels. Also, LPF and HPF are provided for noise output.
NOISE HPF
SINE WAVE
SINE WAVE 2CH
1
1 Oscillator operation mode
• SINE WAVE
• SINE WAVE 2CH
• NOISE (PINK NOISE/BURST NOISE)
NOTE
Oscillator assignments and on/off switching can also be assigned to a USER DEFINED key.
33
CONTENTS
METER
LPF
RIVAGE PM10 Operation Manual
OSC OUT
or
ODD
OSC OUT
EVEN