Yamaha RIVAGE PM10 Operation Manual page 126

System Setup  BUS SETUP
4.
Use the tabs to display the buses for which you want to edit the settings.
5.
Use the SIGNAL TYPE switch buttons to specify whether each bus will function
as STEREO (main parameters will be linked for two adjacent odd-numbered/
even-numbered buses) or MONOx2 (use as two monaural channels).
6.
Use the BUS TYPE select buttons to select the bus type.
SEND POINT (INPUT)
(Specifying the send point for each input channel)
You can select the send destination points for each channel. The send point can be specified for both
when the send source channel is set to PRE and set to POST individually.
1.
Press the SETUP button to access the SETUP screen.
2.
Press the BUS SETUP button to open the BUS SETUP popup window.
This window includes several pages, which you can switch between using the tabs located at
the top of the window.
3.
Press the SEND POINT (INPUT) tab.
The screen contains the following items.
126
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual