Yamaha RIVAGE PM10 Operation Manual page 127

Digital mixing system
Hide thumbs Also See for RIVAGE PM10:
Table of Contents

Advertisement

System Setup  BUS SETUP
6
7
7
2
1
1
Channel select list
Enables you to select a channel.
2
ALL button
Press this button to apply the selected send point to all channels simultaneously.
If the send point is not selected for some channels in the column, "... " will appear.
3
PRE send point select buttons
Enable you to select the send point for each channel for which PRE is turned on. These buttons
correspond to the following parameters.
Button
Send Point
PRE FILTER
Immediately before the filter
PRE EQ
Immediately before the EQ
PRE DYN1
Immediately before DYNAMICS1
PRE DYN2
Immediately before DYNAMICS2
PRE FADER
Immediately before the fader
3
4
5
4
POST send point select buttons
Enable you to select the send point for each channels for which PRE is turned off (POST).
These buttons correspond to the following parameters.
Button
POST FADER
POST ON
5
FOLLOW setting buttons
Enable you to select for each channel whether the signal sent to the MIX/MATRIX bus will
follow the ON/FADER/DCA settings regardless of the send point. These buttons correspond
to the following parameters.
Button
ON
FADER
DCA
6
SEND TO [+]/[−] buttons
Enable you to select the MIX/MATRIX bus channel as the signal destination for a single
channel at a time.
7
SEND TO [<<]/[>>] buttons
Enable you to select the MIX/MATRIX bus channel as the signal destination for 12 channels at
a time.
4.
Use the send point select buttons to specify the send point.
127
CONTENTS
FUNCTION MAP
Send Point
Immediately after the fader
Immediately after the [ON] key
Setting
FOLLOW ON
FOLLOW FADER
FOLLOW DCA
RIVAGE PM10 Operation Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents