Yamaha RIVAGE PM10 Operation Manual page 17

CONTENTS
Connecting a Computer
Connecting a Computer
You can connect a computer with PM10 Editor installed to a DSP engine. To do so, connect the
computer to the NETWORK connector [PC] located next to the TO CONSOLE IN connector. Do
not connect it to the NETWORK connector located above the HY card slots.
Alternatively, you can use the NETWORK connector on the control surface. However, in this case,
please note that the computer will be unable to communicate with the DSP engine if the power to
the control surface is turned off.
NOTE
You can use only one instance of PM10 Editor per system. Do not connect two or more computers to
the system.
DSP Engine
Console Network
or
Control Surface
17
RIVAGE PM10 Operation Manual