Yamaha RIVAGE PM10 Operation Manual page 277

Recording  Multitrack recording/virtual sound check
@ VIRTUAL SOUND CHECK ON button
If this button is on, the Virtual Sound Check function will be enabled, and the patches will be
used for the virtual sound check. When the Virtual Sound Check function is enabled, each
LED on both INPUT [A] and [B] keys light up.
3.
Use the REC OUT select knob to display the port on the slot that will be used for
REC OUT.
4.
Use the knob in the category select list to display channels.
5.
Press the grid cell that corresponds to the REC OUT to patch the channel.
6.
Use the PLAYBACK IN select knob to display the port on the slot that will be
used for PLAYBACK IN.
7.
Use the knob in the category select list to display channels.
8.
Press the grid cell that corresponds to the PLAYBACK IN to patch the channel.
Recording or playing back using a DAW on the computer
Follow the steps below to record or play back using a DAW.
• Setting up the RIVAGE PM10 system
To perform a virtual sound check, configure the recording patches. Recording/playback signals
should be transfered from and received at HY slot 4 on the DSP-R10.
If the RPio622 or RPio222 signal is split out, you do not need to configure the patches. The signals
will be output to the Dante network directly from the HY144-D card inserted in HY slot 2 of the
RPio622.
• Configuring Dante Accelerator or Dante Virtual Soundcard
Configure the Dante network and the computer.
• Setting up Dante patches
Use Dante Controller to configure Dante patches.
• Setting up for a DAW
Select Dante Virtual Soundcard, or AIC128-D ASIO driver.
NOTE
• You must have a license ID to use a Dante Virtual Soundcard. The DVS token that is required for
obtaining the license ID is printed on a sheet (supplied in the HY144-D package).
• The latest information about the Dante Virtual Soundcard and the Dante Controller is available at the
following website:
http://www.yamahaproaudio.com/
■ Configuring Dante Accelerator
First, make sure that the Dante Accelerator card is installed in the PCIe slot of your computer. Then,
install the Dante Accelerator driver. For information about installing the driver and about the
control panel, refer to the Installation Guide supplied with the driver. To achieve a stable live
recording, we recommend you use the maximum buffer size and latency. For more information on
configuring Dante Accelerator, please refer to the Operation Manual for Dante Accelerator.
277
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual