Yamaha RIVAGE PM10 Operation Manual page 362

Setup Procedure and Basic Operation of the RIVAGE PM10 Editor  About the RIVAGE PM10 Editor
Setup Procedure and Basic Operation of
the RIVAGE PM10 Editor
About the RIVAGE PM10 Editor
The RIVAGE PM10 Editor (called "PM10 Editor" in this book) is application software that enables
you to use your computer to perform off-line editing by preparing the RIVAGE PM10 system
settings in advance, and also ¬to monitor and adjust the RIVAGE PM10 system (on-line
monitoring/operation).
DSP Engine DSP-R10
Control Surface CS-R10
NOTE
• Operations in PM10 Editor and operations on the control surface are almost identical.
• Parts of this application software are based on open-source software. For information regarding
software licenses, please see the LICENSE screen.
On-line monitoring/
operation
Off-line editing
Computer running
PM10 Editor
On-line monitoring/operation
1.
Connect a computer (that has PM10 Editor installed) to the DSP engine using
an Ethernet cable.
For more information on configuring the network, please refer to the "RIVAGE PM10 Editor
Installation Guide. "
NOTE
You can use only one instance of PM10 Editor per system. Do not connect two or more
computers to the system.
2.
Start PM10 Editor.
The following screen appears at start-up.
3.
Click the Connect button so that the RIVAGE PM10 system will be linked to
PM10 Editor.
NOTE
If you plan to link channel block selection in PM10 Editor with that on bay R, press [SETUP] 
[PREFERENCES]  MISC tab to access the LINK TO/FROM CONSOLE field, and then set
FADER BANK SEL (BAY R) to On.
362
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual