Yamaha RIVAGE PM10 Operation Manual page 250

Plug-ins  Controlling the parameters of a plug-in
6 OUTPUT knob
Adjusts the output gain.
7 FLAT button
Resets the gain of all bands to 0 dB.
8
Q/TYPE knobs
Control the shape of the frequency response curve for the filter of each band.
For MID 1–4 you can set the steepness (Q) of the frequency response curve. For the LO band
and HI band, you can individually specify one of four filter types.
9
F (frequency) knobs
Specify the center frequency of each filter.
)
G (gain) knobs
Specify the gain of each filter.
!
SW buttons
Toggle each filter on/off. Bands whose filter is turned off are disabled.
■ Dynamic EQ
Dynamic EQ is a newly developed equalizer; it does not emulate any specific model. It provides a
filter through which the same frequency band as the EQ is extracted to a sidechain, allowing the EQ
gain to be varied dynamically when a specific band of the input signal becomes louder or softer, so
that EQ is applied just as you might apply a compressor or expander to a specific frequency band.
For example, by using this on a vocal as a de-esser, you can apply EQ to only that specific band when
sibilants and high-frequency scratchy sounds reach an obtrusive level, obtaining a natural sound
without impairing the original character. There are two full-band Dynamic EQ units, so you can use
them on a variety of material.
3
4
6 5
2
9
8
)
1
BAND ON/OFF button
Switches the corresponding band on/off.
2
SIDECHAIN CUE button
If this button is on, the sidechain signal is sent to the CUE bus for monitoring. In this case, the
graph shows the response of the sidechain filter.
3 SIDECHAIN LISTEN button
If this button is on, the sidechain signal linked to the dynamics is output to the bus (e.g.,
STEREO bus or MIX/MATRIX bus) to which the inserted channel is being sent. In this case,
the graph shows the response of the sidechain filter.
250
CONTENTS FUNCTION MAP
#
1
!
@
7
RIVAGE PM10 Operation Manual