Signal Flow - Yamaha RIVAGE PM10 Operation Manual

CH Parameter  SIGNAL FLOW
In the case of a MIX channel, the following pull-down menu is shown
above the ST/LCR select button.
9 TO STEREO send point
Enables you to select the send point as PRE FILTER, PRE EQ, PRE
DYNA, PRE DELAY, PRE FADER, or POST FADER.
3.
Use the ST/LCR mode select button to select either ST mode or LCR mode for
each channel.
4.
In the channel strip section of the top panel, verify that the [ON] key is turned
on for the input channel or MIX channel that you want to operate, and then
raise the fader to an appropriate position.
5.
Press the top panel TO ST [A]/[B] key to turn it on.
6.
In the channel strip section of the top panel, verify that the [ON] key is turned
on for the STEREO channel that you want to operate, and then raise the fader to
an appropriate position.

SIGNAL FLOW

9
A signal flow window enables you to view the entire signal flow of a single channel. You can also
specify the insert points, delay point, and direct out point in this window. In addition, you can view
the location within the signal flow at which clipping may have occurred.
Viewing the signal flow
1.
Press the [VIEW] key to access the SELECTED CHANNEL VIEW screen.
2.
Press the SIGNAL FLOW popup button to access the SIGNAL FLOW popup
window.
201
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual