Yamaha RIVAGE PM10 Operation Manual page 114

System Setup  SYSTEM CONFIG
RY16-AE OUTPUT1-8/OUTPUT9-16
AES/EBU OUTPUT1-8 of the control surface's rear panel
1
2
3
4
5 6
7
8
1 Patch indication
Indicates the channel that is patched.
2 DELAY button
Switches the output delay on or off.
3 Delay time knob
Sets the delay time of the output port. If you press this when it is selected, the DELAY TIME
popup window will appear. The delay time value is shown above the knob in millisecond units,
and below the knob in the units that are selected in the DELAY SCALE popup window.
NOTE
If the scale is set to ms, the delay time value above the knob is not shown.
4 PHASE button
Switches the phase of the output signal.
5 SRC button
Switches the sampling rate converter on/off for each pair of channels.
9
6 Sampling rate select menu
Selects the output sampling rate when an SRC is turned on.
Choose from SAME AS INPUT (same as the word clock that is input), 44.1 kHz, 48 kHz,
88.2 kHz, or 96 kHz.
7
GAIN knob
Adjusts the output gain of the output port. You can use the screen encoders to make
adjustments. Adjust the setting in 1.0 dB units by turning the knob, or adjust the setting in
0.1 dB units by turning the knob while pressing it. The current value is shown immediately
below the knob.
8 Level meter
Indicates the output level of the signal after level adjustment.
9 Tabs
Switch the input and output display in units of eight channels.
114
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual