Yamaha RIVAGE PM10 Operation Manual page 115

System Setup  SYSTEM CONFIG
MY CARD INPUT
1
2
3 4
5
1 Patch indication
Indicates the channel that is patched.
2 Level meter
Shows the input level.
3
SRC button
Switches the sampling rate converter on/off for each pair of channels.
NOTE
This setting will be ignored if you try to specify it for an MY card that does not support SRC.
4 Clock status display
Indicates the status of the input signal.
5 PHASE button
Switches the phase of the input signal.
NOTE
This is an internal SLOT parameter. It is different than the Ф parameter within the channel
module of the control surface.
6
Tabs
Switch the input and output display in units of eight channels.
6
MY CARD OUTPUT
1
2
3
4
5
6
1 Patch indication
Indicates the channel that is patched.
2 DELAY button
Switches the output delay on or off.
3
Delay time knob
Sets the delay time of the output port. If you press this knob when it is selected, the DELAY
TIME popup window will appear. The delay time value is shown above the knob in
millisecond units, and below the knob in the units that are selected in the DELAY SCALE
popup window.
NOTE
If the scale is set to ms, the delay time value above the knob will not be shown.
4 PHASE
Switches the phase of the signal that is output.
5 GAIN knob
Adjusts the output gain of the output port. You can use the screen encoders to make
adjustments. Adjust the setting in 1.0 dB units by turning the knob, or adjust the setting in
0.1 dB units by turning the knob while pressing it. The current value is shown immediately
below the knob.
115
CONTENTS FUNCTION MAP
7
RIVAGE PM10 Operation Manual