Yamaha RIVAGE PM10 Operation Manual page 300

Scene Memory  Using the Global Paste function
7.
Use the SCENE SELECT knob and a SELECT MODE button to select one or
multiple scenes to which to paste data.
8.
When you finish making settings, press the OK button.
The system will return to the GLOBAL PASTE screen.
9.
If necessary, press the WITH OVERLAY APPLIED button.
A dialog box will appear.
Caution
While Overlay is enabled, if you recall a scene that was previously pasted with added offset
values, both the current offset values and the original offset values will be applied to the scene,
thus doubling the offset value. An extremely high volume sound may be output as a result.
10.
Press the PASTE button.
The selected item(s) in the current scene will be pasted to the specified scene(s) in memory.
A progress bar will appear during the paste operation.
Also, during the paste operation, a STOP button will appear, which you can press to cancel the
paste operation. In this case, data will be pasted up until you press the STOP button. The
operation cannot be reverted.
NOTE
• In any of the following cases, a dialog box will appear and data will not be pasted:
- You attempted to paste data to a protected scene.
- The paste destination scene has been deleted by another operation (from PM10 Editor,
etc.) just before the paste operation was executed.
- If pasting data to one of the paired channels causes the pairing setting to be canceled, the
other channel from that pair will be set to MONO.
300
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual