Yamaha RIVAGE PM10 Operation Manual page 262

Plug-ins  Controlling the parameters of a plug-in
6 LINK knob
If you select the parameter's LINK knob, the display color will change as shown below. The
corresponding parameters for four bands will link together, and the values will change
collectively. Note that if the parameter value of one of the bands reaches the maximum or
minimum, the link operation will stop. Parameters that can be linked are displayed in the
corresponding band color.
7 CROSSOVER
Adjusts the crossover frequencies used to divide the signal into bands.
8 CUE button
Press this button to cue-monitor the output of the corresponding band.
If the IN button is off, a signal without compressor effects will be monitored.
You can turn on the CUE buttons for multiple bands.
9 MASTER GAIN knob
Adjusts the gain of the final output signal.
) INPUT meter
Displays the level of the audio signal input to each band.
! KNEE knob
Adjusts the knee of the compressor.
@ IN button
Switches the compressor on/off for the corresponding band.
Even if this button is off, you will be able to adjust the corresponding band parameters.
#
FLAVOUR button
Switches the type of the compressor between VCA (accurate effects) and OPTO (natural
effects).
$ HARMONICS button
Switches on/off musical harmonics that emulate analog circuitry.
■ OpenDeck
OpenDeck emulates the tape compression created by two open reel tape recorders (a recording deck
and a reproduction deck). You can change the sound quality by adjusting various elements, such as
the deck type, tape quality, playback speed, etc.
1
3
2
4
5
)
1
RECORD: DECK TYPE
Selects the recording deck type.
2
RECORD: LEVEL knob
Adjusts the input level of the recording deck. As you raise the level, tape compression is
generated, which narrows the dynamic range and distorts the sound.
3 RECORD: ADJUST HIGH knob
Adjusts the high range gain of the recording deck.
4 RECORD: BIAS knob
Adjusts the bias of the recording deck.
5 AUTO MAKE UP switch
If you turn this switch on, when you adjust the level of the recording deck (by using the
RECORD/REC LVL knob, the level of the reproduction deck (the REPRODUCE/REPR LVL]
knob) will also change, maintaining the relative output level. You can change the amount of
distortion without changing the output level.
262
CONTENTS FUNCTION MAP
#
6
$
8
7
9
%
! @
RIVAGE PM10 Operation Manual