Yamaha RIVAGE PM10 Operation Manual page 23

Input Channels  Mixing Engine section
9 INPUT TO MIX/INPUT TO MATRIX
A signal can be sent from the input channel to MIX buses 1 – 72. In addition to the conventional
MIX sends, there are also direct sends to MATRIX buses 1 – 36, so by using these together you
can use them as up to 108 mix buses.
• Send Point
This allows you to flexibly select the send point for each channel.
You can set the send point selected here to PRE or POST using the PRE button. You can select
each send point on the BUS SETUP screen.
PRE POST
PRE FILTER POST FADER
PRE EQ POST ON
PRE DYN1
PRE DYN2
PRE FADER
) PAN LINK
With this setting, the signal sent from an input channel to the MIX/MATRIX bus can be made
to follow the PAN of the STEREO bus send regardless of the send point.
!
FOLLOW
With this setting, the signal sent from an input channel to the MIX/MATRIX bus can be made to
"follow" the channel FADER/ON/DCA settings regardless of the send point. For example, you
can select whether or not a PRE FADER monitoring signal will follow the ON/OFF setting for
the STEREO bus send.
Pair setting
Adjacent channels can be paired and used as a stereo module. Either odd-numbered/even-
numbered channels or even-numbered/odd-numbered channels can be specified as a combination.
For a conventional input channel (monaural), the level response of its pan control will be nominal at
center and +3 dB at far left or right.
If channels are paired, the level response of their balance will be nominal at center and +3 dB at far
left or right.
If two channels are paired, all of their parameters except for delay are linked.
Library
The "INPUT CHANNEL LIBRARY" lets you store and recall various input channel parameters.
23
CONTENTS
RIVAGE PM10 Operation Manual