Yamaha RIVAGE PM10 Operation Manual page 197

CH Parameter  SENDS TO/SENDS FROM
■ Using the copy function in the OVERVIEW screen, SENDS TO popup
window, or SENDS FROM popup window
The following table lists the controllers and corresponding parameters.
Screen Controller
OVERVIEW screen SEND knob
SEND ON/OFF button
SENDS TO popup window SEND LEVEL knob
SEND PAN/BALANCE knob
SEND ON button
PRE button
SENDS FROM popup window SEND LEVEL knob
SEND PAN/BALANCE knob
SEND ON button
PRE button
SENDS TO popup window FOLLOW setting buttons
SENDS FROM popup window
* Overlay offset values will not be copied.
1.
In the OVERVIEW screen, while pressing and holding down the [SHIFT] key, press
the SEND LEVEL knob or the SEND ON/OFF button to display the PARAMETER
COPY popup window.
Parameter
Send level*
Send on/off
Send level*
Pan/balance
Send on/off
Send point
Send level*
Pan/balance
Send on/off
Send point
To follow the FADER/ON/
DCA settings.
The window contains the following items.
1 Copy source
Displays the copy source channel (and its destination bus) and the parameter value.
2 Copy destination select knob
Selects the copy destination channel (or its destination bus).
3 SELECT ALL button
Selects all channels (or the destination buses) as the copy destination.
4 REVERT button
Revert the copy destination settings to status obtained when the PARAMETER COPY popup
window was displayed.
5 EXECUTE button
Copies the selected parameter and closes the window.
6 CANCEL button
Aborts the copy operation and closes the window.
2.
Select the copy destination, and then press the EXECUTE button.
The parameter is copied to the selected channel number. To abort the copy operation, press the
CANCEL button instead of the EXECUTE button.
197
CONTENTS
1
2
3
4
6
FUNCTION MAP
3
2
4
5
RIVAGE PM10 Operation Manual