Yamaha RIVAGE PM10 Operation Manual page 359

Panel Settings  Specifying the brightness of the touch screens, LEDs, channel name displays, and lamps
Panel Settings
Specifying the brightness of the touch screens,
LEDs, channel name displays, and lamps
This section explains how to specify the brightness and contrast of individual touch screens, top
panel LEDs and channel name displays, and lamps connected to the rear panel LAMP connectors of
the control surface. You can save four different settings in banks A–D, and select one of them.
1.
Press the SETUP button on the menu bar to access the SETUP screen.
2.
In the field located on the bottom row of the SETUP screen, press one of the
BANK A–D buttons.
You can save four different brightness settings in banks A–D, and switch among them rapidly if
desired.
3.
Use the screen encoders to set the following parameters.
• BANK A–D....................Enable you to select the target bank (A–D).
CONTRAST field
• NAME.............................Adjusts the contrast of the characters in the channel name display
on the top panel.
BRIGHTNESS field
• NAME.............................Adjusts the brightness of the channel name displays on the top
panel. This will also change the CH COLOR brightness. If you want
to adjust the CH COLOR brightness after setting the name display
brightness, use the CH COLOR knob.
• CH COLOR ...................Adjusts the brightness of the channel colors on the top panel. This
lets you apply a relative adjustment to only the channel color
brightness without changing the channel name display brightness.
• PANEL............................Adjusts the brightness of the top panel LEDs.
• SCREEN.........................Adjusts the brightness of the touch screens. If you have set the
brightness to lower than level 2, the system will start up next time
with a brightness setting of 2 so that you will be able to see the
screen.
• LAMP .............................Adjusts the brightness of the lamps connected to the rear panel
LAMP jacks.
4.
If desired, switch among banks A–D, and make settings for the other bank in a
similar manner.
Now you can switch among the BANK A–D buttons to change the brightness of the touch
screens, LCDs, channel name displays, and lamps in a single operation. You can also assign this
parameter to a USER DEFINED key, and press that key to switch among banks A–D.
359
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual