Yamaha RIVAGE PM10 Operation Manual page 251

Plug-ins  Controlling the parameters of a plug-in
4 FILTER TYPE buttons
Switch the type of the main bus equalizer and sidechain filter. The main EQ and sidechain
filter are linked as follows.
FILTER TYPE
(Low Shelf)
Main EQ Low Shelf
Sidechain filter
5 FREQUENCY knob
Specifies the frequency that is controlled by the equalizer and the sidechain filter.
6 Q knob
Specifies the Q (steepness) of the equalizer and the sidechain filter.
Turning the knob toward the right will broaden the region affected by the equalizer and
sidechain filter.
7 THRESHOLD knob
Specifies the threshold value at which the processing effect begins to apply.
8 RATIO knob
Specifies the ratio of boost/cut for the input signal.
Turning this toward the right applies boost, and turning it toward the left applies cut; turning
the knob all the way in either direction produces the maximum effect.
9
ATTACK/RELEASE buttons
Enable you to select one of three settings for the attack time and release time at which
compression or boost is applied.
FAST produces a fast attack and fast release, SLOW produces a fast attack and slow release, and
AUTO automatically adjusts the attack and release according to the frequency region.
) MODE buttons
Specify whether processing operates when the sidechain signal exceeds the threshold value
(ABOVE) or when it falls below it (BELOW).
! EQ GAIN meter
Indicates the gain of the dynamically changing EQ.
@ THRESHOLD meter
Indicates the level of the sidechain signal, referenced to the threshold level.
# Graph display
Indicates the response of the equalizer.
(Bell) (Hi Shelf)
Bell Hi Shelf
LPF BPF HPF
Normally this area shows the reference EQ graph, which indicates the frequency and depth;
and the dynamic EQ graph, which indicates the response of the dynamically changing EQ.
If SIDECHAIN CUE or SIDECHAIN LISTEN is on, this graph shows the response of the
sidechain filter.
251
CONTENTS FUNCTION MAP
Dynamic EQ graph
Reference EQ graph
Sidechain filter graph
RIVAGE PM10 Operation Manual