HIMS Braille Sense U2 User Manual page 346

function without calling up the menu by pressing "Enter-c (dots 1-
4)." Note that you cannot copy folders to send to the local folder.
3) After you have activated this function, you will see the Disk list,
just like when you open the file manager. You will be taken to
"flashdisk" by default. However, if you have SD card or USB
memory stick inserted, you can navigate to those disks by
pressing "Space-1" or "Space-4."
4) After entering a disk, open the menu by pressing "Space-m (dots
1-3-4)." Then, move to "Paste" with "Space-1" or "Space-4," and
press "Enter." You can also activate this function without calling up
the menu by pressing "Enter-v (dots 1-2-3-6)." If the file is larger
than 300 KB, you will also hear the progress meter each time an
additional 10% has been completed. If the file is less than 300 KB,
then you will only hear the sound, and not the progress meter.
5) When the file has been pasted successfully, you will see the
message, "xxx file pasted," where xxx is the name of the file. If the
file is not pasted successfully, you will hear, "xxx file not pasted."
After the file is pasted successfully, you will also hear, "Paste
completed," and you will be returned to the local folder list.
13.2.3.2 Send To
This function will allow you to send files from the local folder list to the
remote folder list. It is only available in the local folder list. This is very
similar to the copy and paste function. The difference is that you do not
have to paste the file to the remote folder. It is done as soon as you
activate the "Send To" function. When you activate this function, the file
can only be sent to the root of the remote folder list. To activate the
"Send To" function, perform the following steps:
1) After the FTP service is connected, you can press "Space-m
(dots 1-3-4)" while you are in the remote folder list to open the
menu. Then, press "Space-1" or "Space-4" to move to "Open Local
Folder," and press "Enter." You can also activate this function
without calling up the menu by pressing "Enter-o (dots 1-3-5)."