HIMS Braille Sense U2 User Manual page 146

by pressing "tab" ("Space-4-5" or "F3"). You can skip an item by pressing
"Space-4" if you do not want to change the default setting.
The following is a detailed explanation of each setting:
1. Set top margin
This sets the top margin for ink printing. The top margin is the
distance from the top of the paper to the first line of the printed
paragraph. The default value is set to 20mm (about 0.78 inches). If
you are going to change the default setting, you can type in a number,
which will make the margin as big as you would like to have it.
2. Set bottom margin
This sets the bottom margin for ink printing. The bottom margin is the
distance from the bottom of the paper to the last line of a printed
paragraph. The default value is set to 20mm (about 0.78 inches). If
you are going to change the default setting, you can type in a number,
which will make the margin as big as you would like to have it.
3. Set left margin
This sets the left margin for ink printing. The left margin is the distance
from the left edge of the paper to the first text that is printed. The
default value is set to 20 mm (about 0.78 inches). If you are going to
change the default setting, you can type in a number, which will make
the margin as big as you would like to have it.
4. Set right margin
This sets the right margin for ink printing. The right margin is the
distance from the right end of the printed text to the right edge of the
paper. The default value is set to 20mm (about 0.78 inches). If you
are going to change the default setting, you can type in a number,
which will make the margin as big as you would like to have it.
5. Set page numbering
This sets the position where the page numbers will be printed. The
page number positions are "Upper left," "Upper middle," "Upper right,"
"Lower left," "Lower middle," and "Lower right." To change the setting,
press "Space." Pressing "Backspace" will allow you to move in
reverse order. After selecting your preference, you should press
"Space-4" in order to move to the next setting.
6. Header