HIMS Braille Sense U2 User Manual page 208

You can save the e-mail id of the sender using the following sequence:
1) Press "Enter-i (dots 2-4)" when "From: (sender's e-mail address)
xx/yy" is displayed.
2) Then, the "add address" dialog box will be opened, and "Name:
(sender's user name or e-mail address)" will be displayed.
3) Type in the sender's name with your Braille keyboard, or press
"tab (Space-4-5)" to move to "Confirm," and press "enter."
When you type in the name, you can type it in directly without pressing
the cursor key to designate the input position on the Braille cell, if you
want to retype the name. But, if you designate a specified position by
pressing a corresponding cursor key, you can modify the displayed
name. If the address that was typed in is saved, and the dialog box is
closed, the Braille Sense U2 will show you the "From" item again.
By saving the e-mail ID using the above method, the name and its e-mail
id will be saved in the Braille Sense U2. The saved e-mail ID can be
used to send your message.
If you want to cancel saving the e-mail ID, press "tab (Space-4-5)" to
move to the "Cancel" button, and press "enter," or just press "Space-e
(dots 1-5)."
8.2.2.4 CC Control
"CC" shows the carbon copy recipient. This control will be shown if the
email has a "CC".
You can save the e-mail id of the carbon copy recipient using the
following sequence:
1) Press "Enter-i (dots 2-4)" when "CC: (carbon copy recipient's e-
mail address) xx/yy" is displayed.
2) Then, the "add address" dialog box will be opened, and "Name:
(sender's user name or e-mail address)" will be displayed.