HIMS Braille Sense U2 User Manual page 212

12) Type in the e-mail address of another recipient using computer
Braille. This e-mail address will not be seen by the recipient or the
carbon copy recipient. If there is no "hidden recipient," you can
skip to next step.
13) Press "tab (Space-4-5)" to move to "Subject:."
14) Type in the subject of the e-mail message at "Subject:" You can
input the subject in ASCII, Grade 1, or Grade 2. You can change
the mode by pressing "Space-g (dots 1-2-4-5)."
15) When you finish typing in the subject, press "tab (Space-4-5)" to
move to "Message body:"
16) You can write an e-mail message. The input method and the
editing method are the same as the input and editing method used
in the word processor. You can also write the message in ASCII,
Grade 1, or Grade 2.
17) When you finish writing the e-mail message, press "Space-m
(dots 1-3-4)" to call up the "E-mail" menu. Then the "File" menu will
be displayed again.
18) Press "enter."
19) Press "Space-4" to move to "Send."
20) Press "enter" when "Send" is displayed. You can send mail
pressing "Enter-s (dots 2-3-4)", without calling up the menu.
21) Then, "Sending..." will be displayed, and the e-mail will be sent
to the recipients. When the Braille Sense U2 finishes sending e-
mail, "Successfully sent new message." will be displayed. If it fails
to send the e-mail, the Braille Sense U2 will display "Unable to
sent message." If this occurs, the e-mail will be saved in the
"Outbox."
If the Braille Sense U2 completed or failed to send the e-mail, it will
return to the "Inbox."
While you execute the above steps, if you want to cancel, press "Space-
e (dots 1-5) or "Space-z (dots 1-3-5-6)". Then it will return to the "Inbox".
8.2.3.1 Attaching file