Auto Scroll; Read Current Sentence - HIMS Braille Sense U2 User Manual

been completed. Once the text has been read, the cursor will move to
the end of the document. To execute this command, press "Space-m
(dots 1-3-4)," and move to the "Read" menu by pressing "Space-4."
Then, press "Enter." You can move to "Read From Cursor To End" by
pressing "Space-4" and press "Enter," or you can press "g (dots 1-2-4-5)"
on the "Read" menu, which is the short cut. While editing a document,
you can press "Enter-g (dots 1-2-4-5)" to activate this function.
If you stop this command before the end of a document, you can press
"Backspace-Enter," which will move the cursor to where you stopped the
command.

5.4.5 Auto Scroll

The "Auto Scroll" command scrolls automatically. The speed of the "Auto
Scroll" is set in the "Settings" menu, which is located in the "File" menu,
which was explained in section 5.1.7. The auto scroll mode does not
read the document using the voice. It is only displayed on the Braille
display. It reads the document line by line automatically. To execute this
command, press "Space-m (dots 1-3-4)" or "F2," and move to the "Read"
menu by pressing "Space-4." Then, press "Enter." Move to "Auto Scroll"
by pressing "Space-4," and then press "Enter," or you can press "a (dot
1)" on the read menu, which is the short cut. You can turn the auto scroll
feature on and off by pressing the up and down scroll buttons
simultaneously. For faster scrolling, press the right "Space-6". For slower
scrolling, press "Space-3". If you want to read a line again that you have
already scrolled past, you can read it again by pressing the up scroll
button or "Space-1" until you can get to what you want to read. Similarly,
if you want to skip some lines that you do not wish to read, you can skip
them by pressing the down scroll button or "Space-4." You can also
access this function without opening the menu by pressing both scroll
buttons at the same time when in your document.

5.4.6 Read Current Sentence