Set Protocol-Protect Priority - Zte ZXR10 2900E Series Command Reference Manual

Parameter Description
Parameter
{group-name}
<0-800>
Example
The following example sets the rate limit of the ZESR protocol per second to 100:
zte(cfg)#set protocol-protect limit zesr 100

4.33.5 set protocol-protect priority

Purpose
This command sets the PP priority.
Command Mode
Global configuration mode
Syntax
set protocol-protect priority{protocol-name|all}{<0-7>|default}
Parameter Description
Parameter
{protocol-name}
all
<0-7>
default
Example
The following example sets the packet priority of the ZESR protocol to 5:
zte(cfg)#set protocol-protect priority zesr 5
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
Group names, including IEEE-reserved1, IEEE-reserved2, ZESR,
loopdetect, arp-reply, 802.1x, IGMP, DHCP, VBAS, PPPoE+,
arp-request, sFlow, UDLD, IPv4,CFM, and route.
Protocol rate limit value.
Description
Protocol names, including 802.1x, arp-reply, arp-request, DHCP,
DHCPv6, EOAM, GM, GVRP, IGMP, IP, IPv6, LACP, LLDP,
loopdetect, MLD, PPPoE+, STP, UDLD, VBAS, and ZESR.
All supported protocols.
Priority value.
Restores the default configuration of the packet priority.
4-507
Chapter 4 Service Configuration
ZTE Proprietary and Confidential