ZXR10 2900E Series Command Reference
In layer-2 egress ACL configuration mode, you can add, delete and move rules for a
specified layer-2 egress ACL.
To return to global configuration mode from layer-2 egress ACL configuration mode, run
the exit command or press Ctrl-Z.
2.1.16 Hybrid Egress ACL Configuration Mode
In global configuration mode, you can run the config egress-acl hybrid number <700-799>
command to enter hybrid egress ACL configuration mode, which is shown as follows:
zte(cfg)#config egress-acl hybrid number 700
zte(egress-hybrid-acl)#
In hybrid egress ACL configuration mode, you can add, delete and move rules for a
specified hybrid egress ACL.
To return to global configuration mode from hybrid egress ACL configuration mode, run
the exit command or press Ctrl-Z.
2.1.17 MAC-Based-VLAN Configuration Mode
In global configuration mode, you can run the config mac-based-vlan session <1-64>
command to enter MAC-Based-VLAN configuration mode, which is shown as follows:
zte(cfg)#config mac-based-vlan session 1
zte(mac-based-vlan)#
In Mac-Based-Vlan configuration mode, you can add or delete rules for a specified session.
To return to global configuration mode from MAC-Based-VLAN configuration mode, run
the exit command or press Ctrl-Z.
2.1.18 User-Defined Ingress ACL Configuration Mode
In global configuration mode, you can run the config ingress-acl user-define number <801-
828> command to enter user-defined ingress ACL configuration mode, which is shown as
follows:
zte(cfg)#config ingress-acl user-define number 811
zte(ingress-user-define-acl)#
In user-defined ingress ACL configuration mode, you can add, delete, or move the rules
of ACLs with the specified ACL numbers.
To return to global configuration mode from user-defined ingress ACL configuration mode,
run the exit command or press Ctrl-Z.
2.2 Common Parameters in Commands
For parameters that are commonly used in the commands of ZXR10 2900E, refer to
2-1.
SJ-20130731155059-003|2013-11-27 (R1.0)
2-6
ZTE Proprietary and Confidential
Table