Set Zdp Holdtime - Zte ZXR10 2900E Series Command Reference Manual

ZXR10 2900E Series Command Reference
Parameter Description
Parameter
<5-255>
Guidelines
The time interval for sending ZDP packets must match ZDP holdtime. If not, discovery
failure occurs. In general, the holdtime should be six times of the time interval for sending
ZDP packets.
Default
The default time interval for sending ZDP packets is 30 seconds.
Example
The following example sets the time interval for sending ZDP packets to five seconds:
zte(cfg-group)#set zdp timer 5

5.6.4 set zdp holdtime

Purpose
This command sets ZDP holdtime.
Command Mode
Cluster management configuration mode
Syntax
set zdp holdtime <10-255>
Parameter Description
Parameter
<10-255>
Default
The default time is 180 seconds.
Example
The following example sets ZDP holdtime to 100 seconds:
zte(cfg-group)#set zdp holdtime 100
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
Time interval for sending ZDP packets. The unit is seconds.
Description
Time (seconds) that the receiving end holds ZDP neighbor status.
5-40
ZTE Proprietary and Confidential