Mac Limit-Num; Mac Protect - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
show mac port-info

mac limit-num

Use this command to configure the number of the MAC addresses
that the physical port can dynamically learn.
Global configuration
mac limit-num [interface <port-name>]<max-number>
interface <port-na
me>
<max-number>
� If the <max-number> value is set to 0, it means that the num-
ber of the MAC address learning is not limited on the interface.
� ZXR10 T160G only supports to set the number of the MAC ad-
dresses that the physical interface can dynamically learn.
This example describes how to set the number of the MAC ad-
dresses that the Ethernet interface fei_1/1 can dynamically learn
to 1000.
ZXR10(config)#mac limit-num ethernet fei_1/1 1000

mac protect

mac protect time
show mac limit-num
show mac running

mac protect

Use this command to enable or disable the port to enter the dy-
namic MAC address learning protection state.
Global configuration
mac protect [interface <port-name>]{disable | enable}
interface <port-na
me>
disable
enable
This command is used together with the mac protect time and m
ac limit-num commands. After the protection of the MAC address
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MAC Configuration
Ethernet physical interface
Maximum number of the MAC addresses that
can be dynamically learned, range: 1~6384
Ethernet physical interface
Disables the MAC address learning protection
Enables the MAC address learning protection
11